Equipment Needed:
- Wireless Xbox 360 Controller
- Tilt Board v3
- Torx T8 Security Bit
- Soldering Iron
- Solder
- Wire
- Double Sided Foam Tape
These instructions will show you how to install the Tilt Board v3 into an Xbox 360 controller. There are two main types of wireless Xbox 360 controller boards. The older boards are known as the matrix version, because the digital inputs are wired as a matrix. The newer board is known as the common ground version because its digital inputs are wired in a simpler common ground fashion. The Tilt Board v3 is designed to work with the newer common ground boards. If you use an older matrix board, your digital inputs will not work correctly. It is very easy to tell which board version you have after you take off the back cover.
To take off the back cover you will need a Torx T8 security bit. This is a very uncommon tool, as there are both Torx T8 and Torx T8 security bits. The security bits have a hole running up the center of the bit to allow for a protruding section of the Torx T8 security screw. There are 7 screws holding the cover on. Six of the screws are clearly visible and one is in the battery compartment under the sticker with a barcode on it. You can either peel the sticker off or poke through the center of it to reach the screw. After the cover is off you should see a board that looks like one of the following: